Information
Replaces The Below V2 Garage and Gate Remotes And Works With The Below Motors
V2 PHOX Remote
V2 PHOX2-433 Remote
V2 PHOX2 Remote
V2 Phox 2 Remote
V2 Phox-2 Remote
V2 Phox-4 Remote
V2 Phoenix Remote
V2 Phoenix-433 Remote
V2 Phoenix-2 Remote
V2 Phoenix-4 Remote
V2 Garage & Gate motors:
V2 Atris Garage Door Opener
V2 Ayros Sliding Gate
V2 Forteco Sliding Gate
V2 Hyperfor Sliding Gate
V2 Torq Sliding Gate
V2 Blitz Swing Gate
V2 Calypso Swing Gate
V2 Nyk Swing Gate
V2 Stark3 Swing Gate
V2 Stark6 Swing Gate
V2 Vulcan Swing Gate
V2 Zorus Swing Gate
Coding Instructions
Coding Instructions Phox V2 Compatible
PLEASE READ INSTRUCTIONS CAREFULLY BEFORE ATTEMPTING TO PROGRAM YOUR NEW REMOTE!
Programming procedure for V2 433 MHz rolling code remote
(requires entry to the gate control box) or garage door cpu board usually under light cover
1. Locate the programming or Radio set button on the MR1 board inside your VR2 gate control enclosure and press it briefly, an LED will flash on the MR1 receiver.PCB., you now have 10 seconds to perform the next step.
2. Take the new transmitter and press the button that you wish to use to operate your receiver until you see the LED flash on the MR1 receiver board.
3.to programme more remotes repeat the process
4. wait 20 seconds- Programming is now complete and your new handset should now operate your receiver.
The MR1 board can be found plugged into the main control board.The programming button does look like a piece of the main casing with a cut out in it